Computational modeling of maxillary canine orthodontic movement

Shai Yona, Oded Medina, Nir Shvalb, Rachel Sarig

פרסום מחקרי: פרסום בכתב עתמאמרביקורת עמיתים

תקציר

Objectives: The current study aims to explore the stress distribution along the roots of palatally positioned maxillary canines during orthodontic movement using a novel computational spring model. Methods: An experimental analysis based on the spring-model was utilized to calculate Orthodontic Tooth Movement (OTM) and the resulting stresses. Two sets of experiments were conducted: the first set compared stresses on a canine resulting from a single force and a force-couple, while the second set simulated canines' traction during instantaneous movement with varying original tooth angulations using different off-the-shelf orthodontic coils. In total, 130 simulations were performed. Results: The model provided estimated stress distribution throughout the OTM with the expected movements, producing consistent outcomes with prior findings. In the first set of experiments, the force couple exhibited an average stress of 43 KPa, while a single force yielded 51 KPa on average. The maximum stress observed was 63 KPa for the force couple and 130 KPa for a single force. Note that the stress distribution attributed to the force couple was alleviated in comparison to the stress distribution caused by a single force. Force couples generated higher average stress. In the second experiment, the application of an occlusally-directed inclined force led to reduced stress levels overall. For instance, when a 200 g distal force was exerted on the canine, it generated an average stress of 20 KPa, whereas applying a force of the same magnitude in an occlusal-distal direction resulted in a lower average stress of 15.5 KPa. Conclusions: Lower average stress levels when using a force couple indicate that larger loads might be safely applied for rotational movements. Given that areas under maximal stress are prone to damage, orthodontic treatment planning should carefully consider stress distribution to minimize potential harm in these high-stress zones. The results also suggest that force couples enable the use of stronger forces than a single force. Additionally, it is advisable to extrude the tooth initially before starting any horizontal movement towards the target position. Clinical significance: Given that orthodontic treatment often relies on virtual planning, incorporating a variety of methods to evaluate stress distribution within the treatment strategy could offer numerous benefits. Such an approach holds the potential to improve both the efficiency and safety of orthodontic treatments, especially in complex cases that require the application of high forces.

שפה מקוריתאנגלית
מספר המאמרe34175
כתב עתHeliyon
כרך10
מספר גיליון14
מזהי עצם דיגיטלי (DOIs)
סטטוס פרסוםפורסם - 30 יולי 2024

טביעת אצבע

להלן מוצגים תחומי המחקר של הפרסום 'Computational modeling of maxillary canine orthodontic movement'. יחד הם יוצרים טביעת אצבע ייחודית.

פורמט ציטוט ביבליוגרפי